When the global pulp and paper industry moves, we report it first — trusted by 12,000+ subscribers across 85 countries
Nippon Dynawave Faces $9.1 Million Workplace Safety Fine, Criminal Charges Referred After Fatal Tank Failure
PAPER INDUSTRY NEWS
Jino John
11/21/20262 min read


Nippon Dynawave Packaging faces $9.1 million in workplace safety penalties and potential criminal charges following an investigation into the May 26 tank failure at its pulp and paper mill in Longview, Washington, that killed 11 workers and injured several others.
The Washington State Department of Labor & Industries (L&I) cited the company for 75 safety violations and referred its investigative findings to prosecutors for consideration of criminal charges. The agency described the violations as “egregious, willful and serious,” citing the company's decision to keep G Tank in operation despite safety concerns.
Investigators also identified problems involving 13 other tanks and concluded that the company's response to the incident exposed additional workers and first responders to danger.
The investigation included interviews with more than 70 witnesses and a review of more than 40,000 documents, including inspection records, internal emails and testing results. L&I Director Joel Sacks said the company had received warnings from consultants and employees but failed to act on the information.
Separately, the Washington Department of Ecology identified more than 34 violations involving air, water and dangerous waste regulations. The company faces $665,000 in compensation for recovery efforts and an additional $296,500 in environmental penalties, bringing the total to approximately $961,500.
The May 26 disaster occurred when G Tank ruptured, releasing hundreds of thousands of gallons of highly caustic white liquor, a chemical solution used in paper manufacturing. The U.S. Chemical Safety Board found that the tank had severely thinned walls despite repeated inspection warnings. Inspections documented dangerously thin walls in July and October 2025 and February 2026, but the tank remained operational until its failure.
Nippon Dynawave said it is reviewing the findings and intends to challenge aspects of the workplace safety report through the appeals process. The company argued that the report did not establish the root cause of the tank failure and said the technical investigation remains ongoing.
The mill has also faced separate safety investigations involving a worker nearly submerged in 145-degree pulp following a drain valve incident and an improperly documented damaged ammonia tank valve.
Most mill employees returned to work earlier in October. Contractors began dismantling G Tank in August, with the work expected to be completed in December.
